Print Page - how to change the "t01, t02 etc to read as minutes rather then hours?

Title: how to change the "t01, t02 etc to read as minutes rather then hours?
Post by: bobinatlanta on January 19, 2024, 06:23:46 PM

How do I change the "t01, t02 etc to read as minutes rather than hours? I do not see a site in the software to do that.
Thanks,
Bob

Title: Re: how to change the "t01, t02 etc to read as minutes rather then hours?
Post by: Kkane on January 22, 2024, 11:37:23 AM

For SYL-23X2P, you cannot change the timer unit. Its timer can only be set by minutes.

For SYL-53X2PA, you can change the timer unit between by minutes or by seconds. You cannot change it by hours. Please adjust parameter SEC under ramp soak step manual accordingly.

For N1050/N20K48, you can change the timer unit between HH:MM or MM:SS. Please adjust Pr.tb parameter under program cycle accordingly.

Auber Forum

PID Control General Discussion => PID Control Discussion => Topic started by: bobinatlanta on January 19, 2024, 06:23:46 PM